What causes Honeywell Security Sensor pump to not operate?
If the pump on your Honeywell Security Sensor is not operating, it could be due to: * The diffusion cap is off or not attached correctly. Attach the diffusion cap and ensure the seal is tight. * There is a blockage in the tubing. Clear the blockage. * The particulate and/or moisture filter requires replacement. Replace the filter(s).
General| Brand | Honeywell |
|---|---|
| Model | GasAlert Max XT II |
| Category | Security Sensors |
| Language | English |
Lists the gases the detector monitors and their units of measure.
Provides critical safety instructions and warnings before using the detector.
Checks detector battery status during startup.
Confirms detector alarms (beeps, flashes, vibrates) during startup.
Verifies the detector's pump operation during startup.
Verifies the detector's operational correctness during startup.
Recommends daily bump testing for sensor response validation.
Details steps for configuring the detector via software.
Sets gas concentration values for calibration.
Describes low alarm conditions and indicators.
Describes high alarm conditions and indicators.
Describes Time-Weighted Average alarm conditions.
Describes Short-Term Exposure Limit alarm conditions.
Warns when the detector battery is low.
Alerts if the detector's pump stops or becomes blocked.
How to view and reset TWA, STEL, and MAX readings.
Triggers for gas alarms based on set levels.
Recommendations for accurate gas calibration.
Step-by-step instructions for performing calibration.
Process for automatically zeroing sensors during calibration.
Process for automatically spanning sensors during calibration.
How to confirm calibration accuracy after performing it.
Guidelines for battery care and safety.
Instructions for charging the detector's battery.
Procedure for replacing the detector's battery.
Procedure for replacing sensors and filters.
To Next Page