9
Honeywell 35 Series IP Cameras User Guide
Select the target device(s) as shown in Figure 5, click and the following figure is
displayed:
Figure 9 IP Assignment
Configure IP Address Setting
• To obtain IP address, subnet mask, and default gateway settings automatically,
select the check box of DHCP.
• To configure IP address, subnet mask, and default gateway settings manually, select
the check box of Manual and enter the settings. If you enter the start IP address, the
system can calculate the end IP address automatically according to the number of
your selected device(s).
• After all settings are completed, click APPLY.
Configure DNS Server Address
Configure the DNS server address and click APPLY.
Upgrading the Camera’s Firmware
Before you begin using your camera, make sure you have the latest firmware installed.
You can upgrade a single camera or multiple cameras at the same time.
Select the Maintenance tab from the left pane as shown in Figure 5, select target
device(s) and click and the following window is displayed:
To Next Page
Loading...
Need help?
General
