32
Honeywell 35 Series IP Cameras User Guide
User name: User name of the mailbox for sending emails.
Password: Password of the mailbox for sending emails.
Sender e-mail address1: Mailbox for sending emails.
Recipient_e-mail_address1: Email address of recipient 1.
Recipient_e-mail_address2: Email address of recipient 2.
Recipient_e-mail_address3: Email address of recipient 3.
Recipient_e-mail_address4: Email address of recipient 4.
Recipient_e-mail_address5: Email address of recipient 5.
Transport mode: Email encryption mode. Set this parameter based on the encryption
modes supported by the SMTP server.
Send interval: The interval for sending ranges from 0 to 60 seconds. The system will not
immediately send the email when the alarm occurs. When an alarm, motion detection, or
other event occurs to activate an email, the system sends one email within the interval
that you have specified here. This reduces the load on the email server when multiple
emails are triggered simultaneously.
Configuring SNMP Settings
Go to Setup > Network Setup > SNMP.
SNMP (Simple Network Management Protocol) is a protocol for collecting, organizing,
and exchanging management information between managed devices on a network.
The SNMP consists of the following three key components:
• Manager: Network-management station (NMS), a server which executes applications
that monitor and control managed devices.
• Agent: A network-management software module on a managed device which
transfers the status of managed devices to the NMS.
• Managed device: A network node on a managed network. For example: routers,
switches, bridges, hubs, computer hosts, printers, IP telephones, network cameras,
web server, and database.
Before configuring SNMP settings on the page, enable your NMS first.
Enable SNMPv1, SNMPv2c: Check to enable SNMPv1, SNMPv2c. SNMPv1 and
SNMPv2c use communities to establish trust between managers and agents. Agents
support three community names, write community, read community and trap.
Write community: Name of write community. The write community only can modify
data.
Read community: Name of read community. The write community only can read data.
To Next Page
Loading...
Need help?
General
