39
Honeywell 35 Series IP Cameras User Guide
6. Check the check boxes to enable Alarm record and SMTP.
7. Click SAVE.
Tampering Detection
Tampering detection identifies the camera tampering based on a set tampering
sensitivity value.
All VA functions are disabled because camera is not on home position. Click
to go
home position before setting Tampering.
1. Go to Setup > Video Analytics > Tampering.
Figure 30 Tampering Detection
2. Check the Enable checkbox to enable tampering detection.
3. Configure the Sensitivity.
4. Configure the detection area.
• Press and hold the left mouse button, and drag in the video area to draw a
detection area
• Click CLEAR to delete a detection area.
5. Select the Output channel.
To Next Page
Loading...