58
Honeywell 35 Series IP Cameras User Guide
IP filter: Check this item and click SAVE to enable the IP filtering function.
Filter type: Select Allow or Deny as the filter type. If you choose Allow Type, only those
clients whose IP addresses are on the Access List below can access the camera, and the
others cannot. On the contrary, if you choose Deny Type, those clients whose IP
addresses are on the Access List below will not be allowed to access the camera, and the
others can.
Click ADD and you can add a filter address.
•
The IPv6 access list column will not be displayed unless you enable IPv6 on the
Network page. For more information about IPv6 Settings, see Enable IPv6 on page
49.
•
The Range rule only applies to IPv4 addresses.
To Next Page
Loading...
Need help?
General
