2.3 AUTO-SEQUENCE CONTROL
The MaxCom Gold has an auto camera-sequencing feature. When turned on, the
MaxCom Gold automatically sequences between the cameras defined in the sequence
on the monitor being controlled by the keyboard. Refer to section 2.3.2 for
programming auto sequences.
Note: If the joystick is moved or a telemetry button is pressed while the keyboard is
auto-sequencing, the auto-sequencing is turned off.
2.3.1 Auto-Sequence On/Off
Pressing the black auto button toggles auto-sequence on and off. When auto-
sequence is on, the black auto button is illuminated.
Note 1: If a user continuously presses the camera button while auto-sequence is on, the
system sequences through only the cameras defined in the sequence. If a camera
defined in the sequence is absent, the MaxCom Gold automatically skips (auto-skip) to
the next camera in the sequence that is present.
Note 2: Auto-sequencing is turned off automatically if the joystick is moved or a
telemetry button is pressed while the monitor under control is auto sequencing. The
black auto button is no longer lit.
Note 3: If a user selects a specific camera (camera number then camera button), auto-
sequencing is turned off and the black auto button is no longer lit.
2.3.2 Programming Auto-Sequences
Camera auto sequences can be programmed by using the MaxCom Gold Menu
Options. Refer to section 7.2.1 to program sequences through the menu options.
Rev. 1 7 900.0560
18-July-2005
To Next Page
Loading...
Need help?
General
