8.3 CONFIGURING THE MAXCOM GOLD
The MaxCom Gold is shipped with default configuration files for 8x1, 8x2, 16x2 and 16x1
series MaxCom. The PC configuration software is also embedded with default
configurations for the various MaxCom Gold models available. The default configuration
can be edited using the PC software utility for the site’s specific needs then transmitted
to the MaxCom Gold. If there are multiple sites that require the same configuration, the
configuration can be saved on the user’s PC and transmitted to other MaxCom Gold
units.
The current configuration in your existing MaxCom Gold can be transmitted to the
software configuration, edited, saved on the PC, and transmitted back to the MaxCom
Gold. Saving the configuration on your PC also provides a backup of your user-specific
configuration.
8.3.1 Opening an Embedded File in the PC Configuration Utility for a Default
Configuration
Perform the following procedure to open a default configuration embedded in the
software configuration utility. This default configuration can be edited for site-specific
needs then transmitted to the MaxCom Gold. It can also be saved on the PC for future
editing or transmitting to other MaxCom Gold units. The user should open the default
configuration and then use 'Save As' on the file menu to avoid corrupting the default
options. If corruption does occur, then the default config can be re-imported from the
HDD.
1. From the main window, click on File.
Rev. 1 54 900.0560
18-July-2005
To Next Page
Loading...
Need help?
General
