8.3.1 Opening an Embedded File in the PC Configuration Utility for a Default
Configuration, Continued
Note: The application software will check which type of MaxCom you are
connecting to and will not allow you to send or receive from a MaxCom with a
different number of monitors and / or cameras than that of the open configuration
file.
A status line on the bottom of the window shows the percentage of completion.
When the default configuration is loaded, the display returns to the main window.
8.3.2 Transmitting a Default Configuration or Current Configuration from a MaxCom
Gold to the PC Configuration Utility
Perform the following procedure to transmit the current configuration stored in the
MaxCom Gold to the software configuration utility. This default configuration can be
edited for site-specific needs then transmitted to the MaxCom Gold. It can also be saved
on the PC for future editing or transmitting to other MaxCom Gold units.
1. Click on Tools.
Rev. 1 56 900.0560
18-July-2005
To Next Page
Loading...
Need help?
General
