| 3
800-22757 - A - 02/2017
Cautions and Warnings
WARNING
Installation and servicing should be performed only by
qualified and experienced technicians to conform to all local codes and to
maintain your warranty.
WARNING
To ensure compliance with electrical safety standards
this product is intended for use with a Listed Power Adapter marked with
“Limited Power Source”, “LPS”, on the unit, output rated 12 V DC,
minimum 0.7 A, Tma=60°C or from Power over Ethernet (PoE) provided by
Listed Information Technology Equipment meeting the IEEE 802.3af PoE
standard.
The Ethernet connection is not intended to be connected to exposed
(outside plant) networks. Do not connect two power sources to the
camera at the same time.
WARNING
To comply with EN50130-4 requirements, a UPS should
be employed when powering the camera from 24 V AC.
CAUTION
Invisible LED radiation (850 nm). Avoid exposure to beam.
To Next Page
Loading...
