PTZ Functions | 81
800-22757 - A - 02/2017
Note You can also go to a preset on the Live View page of the PTZ web client interface.
See PTZ Functions: Preset on page 26 for more information.
Programming PTZ Tours
You can program up to eight tours that can consist of between 2 and 32 preset points in each
tour.
Note You must define the presets before you can program a preset tour.
See Programming a Preset Point on page 79 for more information on
programming preset points.
Figure 6-2 Tour Configuration Interface
Programming a Tour
1. Navigate to Setup PTZ Function Tour (see Figure 6-2).
2. Under the Tour No. and Tour Name table (upper table), click Add. A new tour line is added
to the table. Make sure that the tour line for the tour you want to program is selected
before moving on to the next step.
3. Under the Preset table (lower table), click Add to add a preset to the tour. Continue to click
Add until you have the number of presets that will be needed for the tour (up to 32).
If an added preset line is not needed, click the Delete icon ( ) that is next to the preset
you want to delete.
To Next Page
Loading...
