www.honeywell.com/security
98 | Performance Series IR 1080p IP PTZ Camera User Guide
2. Select a Preset position to enable the Smart Plan for from the Add Plan drop-down list.
You must have at least one preset programmed to enable smart plans (see Programming
PTZ Preset Positions on page 79 for information on programming presets).
3. Click the face detection icon so that it turns orange and click Save.
4. Repeat these steps for other presets if more than one smart plan is needed.
Note Smart Plan must be enabled if you want to use the Face Detection function.
Configure the face detection settings (see Configuring Face Detection on page
98) and then enable Smart Plan to complete face detection setup.
Configuring Face Detection
The Face Detection feature analyzes the video to detect if there are any human faces appearing
in the video. If a face appears it will capture the face with either snapshots, recordings, or alarms
so it can be processed or analyzed by an NVR or user.
Figure 7-7 Face Detection Configuration Interface
Table 7-5 Face Detection Configurations
Parameter Function
Enable Check to enable the Face Detection function.
Working Period
The face detection is activated during the specified period. See
Configuring the Working Period on page 93.
Click Setup. You can configure up to six periods per day. Draw a circle
in the table to enable the corresponding time period. Select a date. If
you do not select a date, the current setup will be applied to today only.
You can select All to apply the working period to the whole week.
Click Save to save the changes. The system goes back to the Face
Detection interface. Click Save to exit.
To Next Page
Loading...
