800-22757 - A - 02/2017
6
PTZ Functions 6
This chapter contains the following sections:
Configuring PTZ Functions
Programming PTZ Preset Positions
You can program up to 300 preset points for the pan/tilt/zoom camera. A preset point is a
pre-programmed position that your PTZ camera can move to automatically when a user selects
a preset to go to.
Programming a Preset Point
1. Navigate to Setup PTZ Function Preset (see Figure 6-1).
2. Click Add to add a new Preset to preset list. If multiple presets are listed, or you want to
modify a preset that was previously configured, make sure the line for the preset you want
to program is selected before performing steps 3 and 4.
• Programming PTZ Preset Positions, page 79
• Programming PTZ Tours, page 81
• Configuring PTZ Scans, page 82
• Configuring PTZ Patterns, page 83
• Configuring Pan Settings, page 85
• Configuring the PTZ Movement Speed, page 85
• Configuring PTZ Idle Motion Actions, page 86
• Configuring Power Up Actions, page 87
• Configuring Time Task Actions, page 88
• Restarting the PTZ Camera, page 89
• Restoring PTZ Default Settings, page 89
To Next Page
Loading...
