www.honeywell.com/security
52 | Performance Series IR 1080p IP PTZ Camera User Guide
Configuring Network Settings
TCP/IP
Figure 5-15 TCP/IP Interface
Table 5-13 TCI/IP Configuration
Parameter Function
Host Name
Configure to set the current host camera’s name. Maximum 32
characters.
Ethernet Card
Select an Ethernet port. The default is Wire.
Note If you modify these settings, you will have to reboot your
camera to activate the new setup.
Mode
Select Static or DHCP mode.
If Static mode is selected, you must manually assign the IP
Address, Subnet mask, and Default Gateway values.
If DHCP mode is selected, the IP Address, Subnet mask, and
Default Gateway are assigned automatically and the fields are
grayed out.
Note IP Address, Subnet mask, Default Gateway
, and
DHCP
are read-only when
PPPoE
is enabled.
MAC Address Displays the MAC address.
IP Version Select the IP version you are using: IPv4 or IPv6.
To Next Page
Loading...
