PTZ Functions | 83
800-22757 - A - 02/2017
Figure 6-3 Scan Configuration Interface
4. Click Set. The Set Left Limit and Set Right Limit buttons will appear.
5. Under the video screen, use the PTZ controls to move the image to the desired left or right
limit position. Adjust the Zoom, Focus and Iris settings using the + and – buttons for
each setting, as required. Click either Set Left Limit or Set Right Limit for the limit
position you have programmed.
6. Repeat step 5 to set the other limit position, so that you have now programmed a left and
right point for the PTZ camera to scan between.
Running a Scan
1. Navigate to Setup PTZ Function Scan (see Figure 6-3).
2. In the Scan No. drop-down list, select the scan that you want to run and click Start.
Note You can also run a scan on the Live View page of the PTZ web client interface.
See PTZ Functions: Scan on page 26 for more information.
Stopping a Running Scan
Use the PTZ controls to move the camera in any direction, or click the Stop button located next
to the Start button to stop the scan.
Configuring PTZ Patterns
You can program up to five pattern tours that can be recalled at a later time. A pattern tour
records your PTZ movements so they can be repeated at a later time.
To Next Page
Loading...
