www.honeywell.com/security
84 | Performance Series IR 1080p IP PTZ Camera User Guide
Programming a Pattern Path
1. Navigate to Setup PTZ Function Pattern (see Figure 6-4).
2. In the Pattern No. drop-down list, select the number of the scan that you want to program
(from 1 to 5).
Figure 6-4 Pattern Configuration Interface
3. Click Set. The Start Rec and Stop Rec buttons will appear.
4. Click Start Rec.
5. Under the video screen, use the PTZ controls to move the camera through the PTZ
movements that you want included in the pattern. If needed, adjust the Zoom, Focus and
Iris settings using the + and – buttons during the pattern recording, as required.
Make sure to program the PTZ pattern as you want it to move when recalled. If you want
the camera to pause at a certain point, make sure to pause before continuing the pattern
movements.
6. Click Stop Rec when you have finished all of the PTZ pattern movements. The pattern
number is now saved.
Running a Pattern
1. Navigate to Setup PTZ Function Pattern (see Figure 6-4).
2. In the Pattern No. drop-down list, select the scan that you want to run and click Start.
Note You can also run a pattern on the Live View page of the PTZ web client interface.
See PTZ Functions: Pattern on page 26 for more information.
To Next Page
Loading...
