Configuring Events and Alarms | 95
800-22757 - A - 02/2017
Configuring Video Tampering
Figure 7-4 Tampering Configuration Interface
Table 7-3 Tampering Configurations
Parameter Function
Enable Check to enable the Video Tamper function.
Working Period
The video masking feature is activated during the specified period. See
Configuring the Working Period on page 93.
You can configure up to six periods per day. Draw a circle in the table
to enable the corresponding time period.
Select a date. If you do not select a date, the current setup will be
applied to today only. You can select All to apply the working period to
the whole week.
Click Save to save the changes. The system goes back to the Video
Tamper interface. Click Save to exit.
Record When Record is enabled, video tampering will trigger a recording.
Record Delay
The system will wait for the specified time before it ends recording.
Select from 10 to 300 seconds.
Send Email
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see SMTP (Email) on page 59).
PTZ
Select the PTZ check box to program the camera to perform a PTZ
action, from Preset, Tour, or Pattern when the tampering event is active.
Select the action from the drop-down list and then the number of the
Preset, Tour, or Pattern to perform from the second drop-down list.
Snapshot
Check to enable the system to save tampering snapshot files (still
images) while the video tampering event is activated. See Path on page
65 for information about configuring where snapshots are saved.
To Next Page
Loading...
