www.honeywell.com/security
56 | Performance Series IR 1080p IP PTZ Camera User Guide
PPPoE
Figure 5-19 PPPoE Configuration Interface
1. Enter the PPPoE Username and Password that you received from the Internet Service
Provider (ISP), and enable the PPPoE function.
2. Click to Save the current setup, and then reboot the camera to activate the PPPoE setup.
The camera connects to the Internet via PPPoE after rebooting.
3. Find the IP address in the WAN from the IP address column.
Note When PPPoE is enabled, disable UPnP so that it does not interfere with PPPoE.
Note You must go to the IP address to check the camera’s current information. You
can access the web client through this address.
DDNS
Manually Configuring the DDNS
Figure 5-20 DDNS Configuration Interface
To set the DDNS, go to the corresponding service website to apply a domain name, and then
access the system through that domain. This works even if your IP address has changed.
To Next Page
Loading...
