Configuring Camera Settings | 55
800-22757 - A - 02/2017
ONVIF
ONVIF (Open Network Video Interface Forum) is a global open standard for the interface of
IP-based security products. The ONVIF specification aims at network video products
interoperability regardless of manufacturer.
Figure 5-18 ONVIF Configuration Interface
The ONVIF setting is disabled by default. To enable ONVIF, click Enable on the ONVIF tab. To
disable ONVIF, click Disable.
RTSP Port
The default setting is 554. The RTSP stream query format is:
Main stream:
rtsp://username:password@ip:port/cam/realmonitor?ch
annel=1&subtype=0
Sub stream:
rtsp://username:password@ip:port/cam/realmonitor?ch
annel=1&subtype=1
You are required to manually enter the following four items: Username,
Password, IP, and Port.
IP: The camera’s IP address.
Port: The default is 554. You can leave this field blank if you are using
the default value.
Follow standard RTP protocols. When the encode mode is MJPEG, the
maximum supported resolution is 2040×2040.
HTTPs Enable the HTTPs port.
HTTPs Port The default is 443.
Table 5-14 Connection Configurations (cont’d)
Parameter Function
To Next Page
Loading...
