Configuring Events and Alarms | 99
800-22757 - A - 02/2017
Note Smart Plan must be enabled if you want to use the Face Detection function.
Configure the face detection settings and then enable Smart Plan to complete
face detection setup (see Configuring a Smart Plan on page 97).
Configuring for Abnormalities
Abnormalities include No SD Card, Capacity Warning, SD Card Error, Network
Disconnection, IP Conflict, and Unauthorized Access.
Configuring for Micro SD Card Abnormalities
Micro SD card Abnormalities include No SD Card, SD Card Error, and Capacity Warning.
Note
Only cameras with Micro SD cards can detect the following abnormalities:
No SD
Card
,
Capacity Warning
, and
SD Card Error
.
Enable Face
Enhancement
Check Enable Face Enhancement to ensure the face is clearly
displayed by priority, even when the stream resolution is low.
Record When Record is enabled, face detection will trigger a recording.
Record Delay
The system will wait for the specified time before it ends recording.
Select from 10 to 300 seconds.
Send Email
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see SMTP (Email) on page 54).
PTZ
Select the PTZ check box to program the camera to perform a PTZ
action, from Preset, Tour, or Pattern when the event is active. Select the
action from the drop-down list and then the number of the Preset, Tour,
or Pattern to perform from the second drop-down list.
Snapshot
Check to enable the system to save snapshot files (still images) while
the face detection event is activated. See Path on page 62 for
information about configuring where snapshots are saved.
Table 7-5 Face Detection Configurations (cont’d)
Parameter Function
To Next Page
Loading...
