Configuring Camera Settings | 49
800-22757 - A - 02/2017
Snapshot
Figure 5-11 Snapshot Configuration Interface
Note See Path on page 51 for information about configuring where snapshots are
saved. Snapshots are saved as JPEGs.
Sub Stream
Bit Rate Type
Select either VBR (variable bit rate) or CBR (constant bit rate).
Note You can select the video quality in VBR mode. The value ranges from
1 to 6.
Reference Bit Rate
Recommended bit rate value according to the resolution and frame rate you
have set.
Bit Rate
With Bit Rate Type: CBR, the bit rate here is the maximum value. In
dynamic video, the system needs a lower frame rate or lower video quality
to adapt to the current bandwidth.
I Frame Interval
Set the number of P-frames between I-frames. The value ranges from 25 to
150. The default value is 50.
The recommended value for
I Frame Interval
is
2 times
the frame rate setting.
SVC
Select the scalable video encoding setting from the drop-down list. Select
from 1(off), 2, or 3. 1(off) is the default setting.
Table 5-10 Snapshot Configurations
Parameter Function
Snapshot Type Select from either General (scheduled) or Event (user activated).
Image Size Same as the main stream resolution.
Quality Select from six levels of image quality.
Interval Set the snapshot frequency from 1S to 7S, or Customized. If you
select Customized you can enter the required interval value in
seconds from 1 to 50000 s.
Table 5-9 Video Bit Stream Configurations (cont’d)
Parameter Function
To Next Page
Loading...
