RT10W Rugged Tablet 5
Replace the Battery
If your battery power is low, you need to either charge the battery in the tablet or
replace it with a charged battery.
Hot Swap
The RT10W Tablet has an internal backup battery that is charged with the main
battery. This battery cannot be removed and requires adequate power for main
battery hot swapping. When the backup battery is fully charged, the tablet can
sustain up to 5 minutes of runtime for battery hot-swapping.
1. Press the Menu button or double-tap to open the Hottab app.
2. Tap Setting to check the power level of the backup battery.
3. If the backup battery level is at least medium, remove the main battery.
Otherwise, charge the tablet until the backup battery level is medium or higher
before removing the main battery.
4. Insert a new, fully charged battery into the battery compartment.
LED Indicator Status
The LED indicators are located in the upper right of the tablet:
Caution: Charge the built-in backup battery every two months to
maintain battery health and prevent possible issues from
battery over-discharge.
LED Name Status
RF Communications Green - WiFi/BT/WWAN/GPS are ON
No light - WiFi/BT/WWAN/GPS are all OFF
Disk Activity Blinking Green - Disk activity is in process
No light - The disk is idling
Battery Orange– The AC adapter is plugged in and the battery is
charging
Blinking green–The AC adapter is plugged in and the
battery is full charged
Solid Red - The battery is low (<10%)
Blinking Red – Battery hot swap is in process
No light – The battery is in use and has more than 10%
charge
Power Blue– Tablet is on
No light– Tablet is off
To Next Page
Loading...
Need help?
General
