Honeywell Sensepoint XCD - Page 62

Sensepoint XCD Technical Manual SPXCDHMANEN Issue 15
62
SPXCDULNCXM
UL/cUL approved Carbon Monoxide 0-500ppm (100 to 1000ppm, 100ppm) with LM25, 3/4’ NPT Entry, with Modbus
SPXCDULNG1M
UL/cUL approved Hydrogen 0-1000ppm with LM25, 3/4’ NPT Entry, with Modbus
SPXCDULNNXM
UL/cUL approved Nitrogen Dioxide 0-50ppm with LM25, 3/4’ NPT Entry, with Modbus
SPXCDULNB1M
UL/cUL approved Carbon Dioxide IR 0-2% v/v with LM25, 3/4’ NPT Entry, with Modbus
SPXCDULNB2M
UL/cUL approved Carbon Dioxide IR 0-5% v/v with LM25, 3/4’ NPT Entry, with Modbus
UL APPROVAL (Epoxy Coated Stainless Steel, SS316, With Modbus)
SPXCDUSNFXM
UL/cUL approved Flammable CAT 0-100%LEL (20,0 to 100.0%LEL, 10%LEL) with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNRXM
UL/cUL approved Methane IR 0-100%LEL (20,0 to 100.0%LEL, 10%LEL) with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNPXM
UL/cUL approved Propane IR 0-100%LEL (20,0 to 100.0%LEL, 10%LEL) with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNO1M
UL/cUL approved Oxygen 25.0% v/v with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNHXM
UL/cUL approved Hydrogen Sulfide 0-50ppm (10.0 to 100.0ppm, 1ppm) with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNCXM
UL/cUL approved Carbon Monoxide 0-500ppm (100 to 1000ppm, 100ppm) with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNG1M
UL/cUL approved Hydrogen 0-1000ppm with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNNXM
UL/cUL approved Nitrogen Dioxide 0-50ppm with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNB1M
UL/cUL approved Carbon Dioxide IR 0-2% v/v with SS316, 3/4’ NPT Entry, with Modbus
SPXCDUSNB2M
UL/cUL approved Carbon Dioxide IR 0-5% v/v with SS316, 3/4’ NPT Entry, with Modbus
Replacement sensor Cartridge
SPXCDXSFXSS
Methane CAT 0-100%LEL (20,0 to 100.0%LEL, 10%LEL)
SPXCDXSRXSS
Methane IR 0-100%LEL (20,0 to 100.0%LEL, 10%LEL)
SPXCDXSPXSS
Propane IR 0-100%LEL (20,0 to 100.0%LEL, 10%LEL)
SPXCDXSO1SS
Oxygen 25.0% v/v only
SPXCDXSHXSS
Hydrogen Sulfide 0-50ppm (10.0 to 100.0ppm, 1ppm)
SPXCDXSCXSS
Carbon Monoxide 0-500ppm (100 to 1000ppm, 100ppm)
SPXCDXSG1SS
Hydrogen 0-1000ppm only
SPXCDXSNXSS
Nitrogen Dioxide 0-10ppm (10.0 to 50.0ppm)
SPXCDXSB1SS
Carbon Dioxide IR 0-2.00% v/v only
SPXCDXSB2SS
Carbon Dioxide IR 0-5.00% v/v only
Accessories
S3KCAL
Calibration cap
SPXCDCC
Collecting cone for use with lighter than air gases
SPXCDDMK
Duct mounting kit
SPXCDMTBR
Pipe Mounting bracket (including fixings and hex wrench set)
SPXCDSDP
Sunshade / Deluge Protection
SPXCDHMANEN
Hard Copy Manual in English language
SPXCDHMANCN
Hard Copy Manual in Chinese language
SPXCDHMANKR
Hard Copy Manual in Korean language
Spares
SPXCDDMT12
Replacement display module (O2 & Toxic)
SPXCDDMF12
Replacement display module (FL & IR)
SPXCDTMO12
Replacement terminal module (O2)
SPXCDTMT12
Replacement terminal module (Toxic)
SPXCDTMF12
Replacement terminal module (FL & IR)
SPXCDMBUS
Replacement Modbus Module
SPXCDSERVK
Service Kit containing all o-rings, terminal module and locking screws
SPXCDTOOLK
Factory toolkit containing magnetic wand and hex wrenches for locking and earth screws
SPXCDTMK
Terminal block set
SPXCDNPTP
3/4’ NPT Plug
SPXCDM20P
M20 Plug
SPXCDMANCD
Instruction manual CD-ROM
SPXCDNADP
3/4’ NPT to M20 Adaptor
SPXCDWP
Weather Protection
SPXCDSRLS
Sensor Retainer with locking screw
SPXCDEBS
Earth Bracket and Screws
Special Flammable Gas Calibration
SPXCDSFGC1
Special Flammable Gas Calibration, 0-100%LEL, 1*
SPXCDSFGC2
Special Flammable Gas Calibration, 0-100%LEL, 2*
SPXCDSFGC3
Special Flammable Gas Calibration, 0-100%LEL, 3*
SPXCDSFGC4
Special Flammable Gas Calibration, 0-100%LEL, 4*
SPXCDSFGC5
Special Flammable Gas Calibration, 0-100%LEL, 5*
SPXCDSFGC7
Special Flammable Gas Calibration, 0-100%LEL, 7*
SPXCDSFGC8
Special Flammable Gas Calibration, 0-100%LEL, 8*
Note: If no Special Flammable Gas Calibration part no. is included on PO, a Methane (6* calibration will be supplied)
* AP approvals include GB & PA for China and KTL for Korea.