Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page iii
About This Manual
This manual is a detailed how to reference for installing, piping, wiring, configuring, starting up,
operating, maintaining, calibrating, and servicing Honeywell’s family of ST 800 SmartLine
Pressure Transmitters. Users who have a Honeywell ST 800 SmartLine Pressure Transmitter
configured for HART protocol or Honeywell’s Digitally Enhanced (DE) are referred to the ST
800 Series HART/DE Option User’s Manual, document number 34-ST-25-38. Users who have a
Honeywell ST 800 SmartLine Pressure Transmitter configured for Fieldbus operation are referred
to the ST 800 Series Fieldbus Option User’s Manual, document number (34-ST-25-39).
The configuration of your Transmitter depends on the mode of operation and the options selected
for it with respect to operating controls, displays and mechanical installation. This manual
provides detailed procedures to assist first-time users, and it further includes keystroke
summaries, where appropriate, as quick reference or refreshers for experienced personnel.
To digitally integrate a Transmitter with one of the following systems:
For the Experion PKS, you will need to supplement the information in this document with the
data and procedures in the Experion Knowledge Builder.
For Honeywell’s TotalPlant Solutions (TPS), you will need to supplement the information in this
document with the data in the PM/APM SmartLine Transmitter Integration Manual, which is
supplied with the TDC 3000 book set. (TPS is the evolution of the TDC 3000).
Release Information:
ST 800 SmartLine Pressure Transmitter User Manual, Document # 34-ST-25-35,
Rev. 1, October, 2012 – First Release
Rev. 2, January 2013 – Document # reference and meter body updates
Rev. 3, February 2013 – Parts list updates
Rev. 4, May 2013 – Updates to Parts list, Explosionproof Seal class, Fail Safe and Comms
Module procedures.
Rev. 5, July 2013 – Control Drawing updated to Rev.D
Rev. 6, Feb 2014 - Advanced display updates. Approvals FISCO & GOST added. PILD, Dual
and Triple Calibration added.
Rev.7, May 2014 – PILD, Basic Display and High Pass Frequency updates
Rev.8, July 2014 – PILD update referencing the Option upgrade instructions
Rev.9, December 2014 – MID and Marine Approvals added
Rev.10, July 2016 – DE added to voltage chart, Approval updates and EU cert.
To Next Page
Loading...
Need help?
General
