Honeywell ST 800 - 4.2.1 Menu Navigation

Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page 27
Table 7 – Three-Button Option Functions
Physical
Button
Basic Display
Advanced Display
Action
Left

Increment
Previous Menu Item
Increment
Move cursor Up
Scroll to previous menu item in an active list.
Scroll through alphanumeric list to desired
character (ex. for entering Tag names or
numeric values)
Center

Decrement
Next Menu Item
Decrement
Move cursor Down
Scroll to next menu item in an active list.
Scroll through alphanumeric list to desired
character (ex. for entering Tag names or
numeric values)
Right

Select displayed
menu item for
activation or editing
Enter
Call up the Main Menu.
Call up a lower-level menu.
Select an item for data entry.
Confirm a data entry operation
Activate the service associated with a
selected menu item.
4.2.1 Menu Navigation
The behavior of the buttons is the same for both the Basic and Advanced Displays. The user must
press  button to call up the Main Menu. To exit the Main Menu and return to the PV display
screen, select <EXIT>.
When on a lower level menu, return to the menu above by selecting <Return>. Alternately, the (up)
and (down) buttons can be pressed simultaneously to return to the menu above. When on the highest
level menu, or when using the basic display menu, pressing the (up) and (down) buttons
simultaneously will exit the menu and return to the PV display.
Use the  and  buttons to scroll through the list of menu items. Press the  button to select an item
for data entry or activation. When an item is selected for data entry or activation, the cursor will jump
to the lower line of the LCD (Basic Display) or call up a pop-up window (Advanced Display) to
allow editing of the value. No action is taken against a menu item until the  button is pressed.
If a user presses the  button to begin a data entry operation, they must press another button within
10 seconds or the transmitter firmware will assume that the user wants to abort the operation or has
walked away from the transmitter. After 10 seconds with no action, the data entry will time out and
the original value of the parameter will be preserved.
If no button presses occur within 60 seconds, menu access will time out and the transmitter will exit
the menu and return to the PV display.