Honeywell ST 800 - 4.5 Monitoring the Basic and Advanced Displays

Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page 47
Table 14 – Information Menus
<Return> Return to the Level 1 menu
Display
<Return>
Firmware Version
The firmware version of the Display Module
Read
Only
Elec
Module
<Return>
Firmware Version
The firmware version of the Electronics Module
Read
Only
HART/DE Version
The firmware version number of the Electronics Module
as displayed via the HART and DE protocols
Read
Only
Protocol
The communications protocol of the transmitter:
 HART: HART protocol
 DE: Honeywell DE protocol
 FF: Foundation Fieldbus
Read
Only
Meterbody
<Return>
Firmware Version
The firmware version of the Meterbody
Read
Only
Model Key
Identifies the type and range of the transmitter
Read
Only
Units
The Engineering Units for the LRL and URL.
Note that you can change these Units from the
Transmitter Setup menu, if desired (Transmitter
Setup\Parameters\Units)
Read
Only
LRL
The Lower Range Limit of the Meterbody
Read
Only
URL
The Upper Range Limit of the Meterbody
Read
Only
Options
<Return>
PILD
Available/Not Available
Read
Only
Serial Number
Unique serial number of the transmitter
Read
Only
License Key
########
License key to enable PILD option
Write
only
(enter
numeric
license
key
4.2.6 The Basic Display Menu
The Basic Display Menu is implemented as one long single-level menu and will “wrap around” when
it reaches the start or end of the menu. Operation is as follows:
Press the  button to call up the Menu.
1. Select <Exit Menu> and press  to exit the Menu.
2. Use the  and  buttons to scroll through the list of menu items.