Honeywell ST 800 - 4.2.4 Selecting a new setting from a list of choices; 4.2.5 The Advanced Display Menus

Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page 29
4.2.4 Selecting a new setting from a list of choices
Use the procedure described below to select a new setting for parameters that present a list of choices
(e.g., Screen Format, Display Units, etc.).
1. Press  to begin the edit process.
a. The Basic Display will show the current setting of the item on the lower line, left
justified.
b. The Advanced Display will show the current setting of the item in a pop-up window.
2. Press the  or  buttons to scroll through the list of choices.
3. Press  to make your selection. The new selection will be stored in the transmitter and will
be displayed on the lower line, right justified.
4.2.5 The Advanced Display Menus
The Advanced Display menus are organized into three levels, as shown by Table 9. There is a
<Return> menu item at each level that allows the user to return to the previous level.
Table 9 – Advanced Display Main Menu Structure
Level 1
Level 2
Level 3
<Exit>
n/a
n/a
Diagnostics
Critical
Non-Critical
PILD (Optional)*
For details go to the Diagnostics Menu table
Display Setup
LCD Contrast
Common Setup
Screen 1
Screen 2
…
Screen 8
For details go to the Display Setup Menu table.
Note that the Advanced Display supports the
configuration of up to 8 different screens.
Calibration
Set Time Stamp
Zero Correct
LRV Correct
URV Correct
Reset Corrects
DAC Trim
Loop Test
Factory Cal
For details go to the Calibration Menu table.
Transmtr Setup
Parameters
Enter LRV
Enter URV
Set LRV
Set URV
Install date
PILD (Optional)*
For details go to the Transmitter Setup Menu
table.
Information
Display
Elec Module
Meterbody
For details go to the Information Menu table.
*This feature is available only if ST 800 Sensor supports PILD feature.