Honeywell ST 800 - 6 Calibration; 6.1 Recommendations for Transmitter Calibration; 6.2 Calibration Procedures

Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page 59
PV Function Block
Mode
The Function Block Mode is only displayed for Foundation Fieldbus
transmitters. The eight possible Modes are shown below.
OOS Out Of Service
Auto Automatic
Man Manual
Cas Cascade
RCas Remote Cascade
Rout Remote Output
IMan Initialization Manual
LO Local Override
Process Variable Tag
User Configurable. This field has 14 characters
Engineering Units
User Configurable. This field has 8 characters
Pressure:
atm
bar
fttH2O
gf/cm2
inH20 @ 39F
inH20 @ 60F
inH20 @ 68F
inHg @ 0C
kgf/cm2
Pressure:
kPa
mbar
mmH2O @ 4C
mmH2O @ 68F
mmHg @ 0C
mPa
Pa
psi
Torr
mH2O @ 4C
mHg @ 0C
Temp:
o
C
o
F
o
R
K (Kelvin)
Other:
Percent (%)
milliamp (mA)
Custom Text
Flow:
gal/min
gal/h
L/min
L/hr
Square Root Output
This indicator is displayed when the Transfer Function of the transmitter is
set to “Square Root”.
Note that this indicator is not displayed on the Trend screens.
Bar Graph
The limits of the bar graph are user-configurable for each screen.
Trend Graph
The limits of the trend graph are user-configurable for each screen.
The amount of time visible on the Trend graph is also configurable.
4.5.3 Button operation during monitoring
When the operator screens are active on the Advanced Display, the Increment and Decrement buttons
( and ) can be used to move to the next or previous operator screen without waiting for the rotation
time to expire. Pressing the Enter button (  ) will call up the Main Menu.