Honeywell ST 800 - Table 11 - Display Setup Menus

Page 32 ST 800 SmartLine Pressure Transmitters User’s Manual Revision 10
Table 11 – Display Setup Menus
<Return> Return to the Level 1 menu
LCD
Contrast
<Return>
Set
Contrast
# #
Adjust the LCD contrast level.
Range from 0 to 9.
Default: 5
Press  to enter
menu selection
 and  to select
number.
 to enter and shift to
next digit
Common
Setup
<Return>
Set
Password
####
Enter Display configuration
password. Default: 0000.
This value disables the
password. All other values enable
the password. When enabled, a
prompt to enter the password is
presented only on the first
parameter successfully accessed
to change after entering the
menu.
Language
 English, French,
German, Italian,
Spanish, Russian
& Turkish
 English, Chinese,
Japanese
Select the language for the
Display.
Default: English
Press  to enter
menu selection
 and  to select
from list.
 to enter
Rotation
Time
# #
Time duration, in seconds, that
each configured screen is
shown before moving to the next
screen.
Range: 3 to 30 seconds
Default: 10 seconds
Press  to enter
menu selection
 and  to select
number.
 to enter and shift to
next digit
Units
atm
bar
ftH2O @ 68F
gf /cm2
inH2O @ 39F
inH2O @ 60F
inH2O @ 68F
inH2O @ 0C
kgf/cm2
kPa
mbar
mmH2O @ 4C
mmH2O @ 68 F
mmHg @ 0 C
MPa
Pa
psi
Torr
This selection determines the
units of the values shown on the
following menu items:
 Enter LRV
 Enter URV
 Set LRV
 Set URV
 Zero Correct (Calib. menu)
 LRV Correct(Calib. menu)
 URV Correct(Calib. menu)
 LRL (Meterbody Info. menu)
 URL (Meterbody Info. menu)
For calibration, this parameter
allows the user to match the
value displayed on the menus to
Press  to enter
menu selection
 and  to select
from list
 to enter