Honeywell ST 800 - Page 43

Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page 33
the units supported by the user’s
calibration equipment.
Screens
1 thru 8
<Return>
Screen
Format
None
Select the Screen format from
the list.
Press  to enter
menu selection
 and  to select
from list.
 to enter
PV
PV & Bar Graph
PV & Trend
Trend
Duration
##
Select the amount of historic
data visible on the Trend screen.
Range: 1 to 24 hours.
Applies to the “PV & Trend”
format only
Press  to enter
menu selection
 and  to select
number.
 to enter and shift to
next digit
PV
Selection
DP, AP, or GP
Pressure
Select the Process Variable
(PV) that will be shown this
screen.
Press  to enter
menu selection
 and  to select
from list.
 to enter
Meterbody Temp
Loop Output
Percent Output
Static Press
PILD Factor
(Optional)
See Note 3 below
PV
Scaling
None
Display the PV in the default
units associated with the PV
Selection. Default units:
 Pressure:inH2O@ 39ºF
 Meterbody Temp: ºC
 Loop Output: mA
 Percent Output: %
 Static Pressure: psi
Press  to enter
menu selection
 and  to select
from list.
 to enter
Custom Units:
 and  to select
Alphanumeric
 to enter and shift to
next char
Convert Units
(Default PV scaling
selection)
Convert the displayed PV to any
pressure unit listed under
Display Units
Linear
See Note 1 below
Display
Units
Custom
Units up to 8
char
Square Root (only
available for DP
transmitters)
See Note 2 below.
Display
Units
%
Custom
Units
up to 8 char
gal/min
gal/h
L/m
L/h