Page 48 ST 800 SmartLine Pressure Transmitters User’s Manual Revision 10
3. Press the button to select an item for data entry or activation. When an item is selected for
data entry or activation, the cursor will jump to the lower line of the LCD to allow editing of
the value. No action is taken against a menu item until the user presses the button.
4. If you want to abort a data entry operation, simply refrain from pushing any buttons for 10
seconds; the data entry operation will time out and the original value of the selected item will
be preserved.
Table 15 – The Basic Display Menus
Adjust the LCD contrast level.
Range from » (1) to »»»»»»»»»
(9)
Default: »»»»»»» (7)
Press to enter
menu selection
and to select
level.
to enter
Select Process
Variable (PV) to
be shown on the
display from list.
Press to enter
menu selection
and to select
from list
to enter
Select the PV decimal resolution
to be shown on selected screen
from list.
(Available only
when Custom
Output PV Display
is selected)
Enter custom text using any
alphanumeric value up to 8
characters long.
and to select
Alphanumeric
to enter and
shift to next
character
(Available only
when Custom
Output PV Display
is selected)
Enter the low and high scaling
limits. These limits are used to
scale the loop output to the
desired value.
Press to enter
menu selection
and to select
number.
to enter and
shift to next digit
(Available only
when Custom
Output PV Display
is selected)
Enter Custom Tag using and
alphanumeric value up to 14
characters long
Press to enter
menu selection
and to select
Alphanumeric
to enter and
shift to next
char.
To Next Page
Loading...
