Honeywell ST 800 - Page 59

Revision 10 ST 800 SmartLine Pressure Transmitters User’s Manual Page 49
Range / Cal Units
atm, bar
ftH2O @ 68ºF
gf/cm2
inH2O @ 39ºF
inH2O @ 60ºF
inH2O @ 68ºF
inHg @ 0ºC
kgf/cm2, kPa
mbar,
mmH2O @ 4ºC,
mmH2O @ 68ºF,
mmHg @ 0ºC,
MPa, Pa,
psi
Torr,
mH2O @ 4ºC
mHg @ 0ºC
Choose engineering units for LRV,
URV and Corrects values
Press  to enter
menu selection
 and  to select
from list
 to enter
Pressure Units
(Available only
when Pressure PV
Display is selected)
atm, bar
ftH2O @ 68ºF
gf/cm2
inH2O @ 39ºF
inH2O @ 60ºF
inH2O @ 68ºF
inHg @ 0ºC
kgf/cm2, kPa
mbar,
mmH2O @ 4ºC,
mmH2O @ 68ºF,
mmHg @ 0ºC,
MPa, Pa,
psi
Torr,
mH2O @ 4ºC
mHg @ 0ºC
Choose appropriate engineering
units from list
Press  to enter
menu selection
 and  to select
from list
 to enter
Zero Correct
Do Correct
Executing this selection corrects
the Zero based on the input
pressure
Press  to enter
menu selection
Press  to
initiate action
LRV Correct
Do Correct
Executing this selection corrects
the LRV based on the input
pressure
URV Correct
Do Correct
Executing this selection corrects
the LRV based on the input
pressure
Reset Corrects
Do Correct
Executing this selection Resets
the Zero, LRV, and URV Corrects
back to Factory values