Honeywell Stratos 2700 - Page 229

13 - 11
Character Deactivation Mode *Off HSTDEN0 4-16
On HSTDEN1 4-16
Deactivation Character HSTDCH## 4-16
Output Sequence Editor Enter Sequence SEQBLK 4-18
Default Sequence SEQDFT 4-18
Sequence Timeout (Range 1 - 65535) *5000 ms SEQDLY##### 4-19
Sequence Match Beeper *On SEQBEP1 4-19
Off SEQBEP0 4-19
Partial Sequence Transmit Partial Sequence SEQTTS1 4-19
*Discard Partial Sequence SEQTTS0 4-19
Require Output Sequence Required SEQ_EN2 4-20
On/Not Required SEQ_EN1 4-20
*Off SEQ_EN0 4-20
No Read On SHWNRD1 4-20
*Off SHWNRD0 4-20
Programming the Auxiliary Scanner Interface
Scanner to Bioptic Communication
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 5-1
Packet Mode On 232PKT2 5-1
ACK/NAK ACK/NAK On 232ACK1 5-1
*ACK/NAK Off 232ACK0 5-1
Communication Timeout Range 0 - 65535ms *2000 232DLK##### 5-1
Honeywell Scanner Aux Port Configuration Honeywell Aux Scanner AUXDFT 5-2
Datalogic Magellan Aux Port Configuration Datalogic Magellan Aux Scanner AUXMAG 5-2
NCR Bioptic Aux Port Configuration NCR Aux Scanner AUXNCR 5-2
Wincor Nixdorf Beetle Aux Port
Configuration
Wincor Nixdorf Beetle Aux Scanner AUXBTL 5-2
Good Read Beep - Aux Scanner *Good Read Beep - Bioptic and Aux Scanner AUXBEP1 5-3
Good Read Beep - Aux Scanner AUXBEP0 5-3
Aux Scanner D/E Commands Use D/E Commands AUXDEC1 5-3
*Do Not Use D/E Commands AUXDEC0 5-3
Reread Delay Override *Reread Delay from Aux Scanner AUXDSS1 5-3
Reread Delay from Bioptic AUXDSS0 5-3
Scale
RS232 Baud Rate/Parity 232BAD5;2332WR
D2
6-1
Single Cable SCLSGL1 6-1
External Scale Display SCLDSP1 6-1
NCR Protocol English (lbs) - Single Cable PAP956 6-1
NCR Protocol Metric (kg) - Single Cable PAP955 6-1
*POS - Don’t Beep on Send Weight NCRBWS0 6-2
POS - Beep on Send Weight NCRBWS1 6-2
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page