Honeywell Stratos 2700 - Page 231

13 - 13
Communication Check Character *None HSTXRC0 7-5
LRC Starts on 1st Character HSTXRC1 7-5
LRC Starts on 2nd Character HSTXRC2 7-5
CRC HSTXRC3 7-5
Intercharacter Delay Range 0 - 65535 (1ms increments) DLYCHR## 7-5
User Specified
Intercharacter Delay
Delay Length
Range 0 - 65535 (1ms increments)
DLYCRX## 7-6
Character to Trigger Delay DLY_XX## 7-6
Interfunction Delay Range 0 - 65535 (1ms increments) DLYFNC## 7-6
Intermessage Delay Range 0 - 65535 (1ms increments) DLYMSG## 7-6
Data Formatter Selections
Data Format Editor *Default Data Format (None) DFMDF3 8-1
Enter Data Format DFMBK3## 8-2
Clear One Data Format DFMCL3 8-2
Clear All Data Formats DFMCA3 8-2
Data Formatter Data Formatter Off DFM_EN0 8-11
*Data Formatter On,
Not Required,
Keep Prefix/Suffix
DFM_EN1 8-12
Data Format Required,
Keep Prefix/Suffix
DFM_EN2 8-12
Data Formatter On,
Not Required,
Drop Prefix/Suffix
DFM_EN3 8-12
Data Format Required,
Drop Prefix/Suffix
DFM_EN4 8-12
Data Format Non-Match Error Tone *Data Format Non-Match Error Tone On DFMDEC0 8-12
Data Format Non-Match Error Tone Off DFMDEC1 8-12
Primary/Alternate Data Formats Primary Data Format ALTFNM0 8-13
Data Format 1 ALTFNM1 8-13
Data Format 2 ALTFNM2 8-13
Data Format 3 ALTFNM3 8-13
Single Scan Data Format Change Single Scan-Primary
Data Format
VSAF_0 8-13
Single Scan-Data Format 1 VSAF_1 8-13
Single Scan-Data Format 2 VSAF_2 8-13
Single Scan-Data Format 3 VSAF_3 8-13
Symbologies
All Symbologies All Symbologies Off ALLENA0 9-1
All Symbologies On ALLENA1 9-1
Codabar Default All Codabar
Settings
CBRDFT 9-2
*Off CBRENA0 9-2
On CBRENA1 9-2
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page