Honeywell Stratos 2700 - Page 235

13 - 17
ISBT 128 User-Defined Concatenation
Sequences
1st Left Identifier (0-255) *0 ISBUL1## 9-23
2nd Left Identifier (0-255) *0 ISBUL2## 9-23
1st Right Identifier (0-255) *0 ISBUR1## 9-23
2nd Right Identifier (0-255) *0 ISBUR2## 9-23
ISBT 128 User-Defined Concatenation
Sequences On/Off
*Off ISBUCE0 9-24
Allow User-Defined Sequence ISBUCE1 9-24
Require User-Defined Sequence ISBUCE2 9-24
Content Verification *Off ISBXM00 9-24
On ISBXM01 9-24
Transmit Identifiers Off ISBXM10 9-25
*On ISBXM11 9-24
Flag Conversion *Off ISBXM20 9-25
On ISBXM21 9-25
GS1-128 Default All GS1-128 Settings GS1DFT 9-26
On GS1ENA1 9-26
*Off GS1ENA0 9-26
GS1-128 Application Identifier Parsing *Off GS1EMU0 9-26
Transmit Without Identifiers GS1EMU1 9-26
Transmit With Identifiers GS1EMU2 9-26
GS1-128 Redundancy Range (0 - 10) *0 GS1VOT## 9-27
GS1-128 Message Length Minimum (1 - 80) *3 GS1MIN 9-27
Maximum (1 - 80) *80 GS1MAX 9-27
Telepen Default All Telepen
Settings
TELDFT 9-28
*Off TELENA0 9-28
On TELENA1 9-28
Telepen Output *AIM Telepen Output TELOLD0 9-28
Original Telepen Output TELOLD1 9-28
Telepen Redundancy Range (0 - 10) *0 TELVOT## 9-28
Telepen Message Length Minimum (1 - 80) *3 TELMIN## 9-29
Maximum (1 - 80) *80 TELMAX## 9-29
UPC-A Default All
UPC-A Settings
UPADFT 9-29
Off UPBENA0 9-30
*On UPBENA1 9-29
UPC-A Check Digit Off UPACKX0 9-29
*On UPACKX1 9-29
UPC-A Number System Off UPANSX0 9-30
*On UPANSX1 9-30
UPC-A 2 Digit Addenda *Off UPAAD20 9-30
On UPAAD21 9-30
UPC-A 5 Digit Addenda *Off UPAAD50 9-30
On UPAAD51 9-30
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page