Installation and configuration 19
Initial SCS login
The SCS ships with a single user defined in its user database. The first time you connect to the SCS, you are prompted
for a user name.
1. At the Username prompt, enter
Admin. There is no factory default password for the Admin user. At the
Password prompt, press the Enter key.
Username: Admin
Password:
Authentication Complete
SCS configuration is required
2. After authentication completes, the SCS prompts for any missing configuration values that are required for
operation.
If you already provided the IP address, subnet mask, and gateway, you are not prompted for those values again.
If you have not already provided the network information, you are prompted for them. Enter the addresses using
standard dot notation.
SCS configuration is required
Enter SCS IP address > 192.168.0.5
Enter SCS Subnet mask > 255.255.255.0
Enter SCS Gateway address > 0.0.0.0
3. You are prompted for a new Admin password. Passwords are case-sensitive and must contain three to 16
alphanumeric characters. You must enter the new password twice to confirm that you entered it correctly.
Enter SCS New Admin Password > *****
Confirm New Admin Password > *****
After you have provided the required configuration information, a confirmation message appears while the SCS
stores the values in its configuration database.
You have now completed the initial login, and you can enter additional commands at the CLI prompt (>). To
configure other SCS ports, see “Configuring serial port settings.”
Rebooting the SCS
You can reboot the SCS by pressing the recessed button on the SCS front panel or by issuing a command.
During a reboot, any active Telnet sessions, including your own, are terminated. Any configuration changes that
require a reboot become effective when the reboot completes.
To reboot the SCS hardware:
1. Locate the recessed reset button on the front of the SCS.
2. Insert the opened paper clip into the recess, and then press the button.
To reboot the SCS with a command, issue the server reboot command. See “SCS commands.”
To Next Page
Loading...
Need help?
General
