HP 16-port SCS User Manual

SCS commands 67
Server SSH command
The Server SSH command enables or disables SSH session access to the SCS and specifies the SSH authentication
method. When you enable SSH, all SCS sessions will be terminated if an SCS SSH server key must be generated.
You must also have previously specified an authentication method other than None with the Server Security
command.
If you enable plain text Telnet connections with a Server Security command, enabling SSH session access with
the Server SSH command will add that as a valid connection method (both plain text and SSH connections will be
allowed.) See “Using SSH.”
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server ssh enable|disable [auth=<auth>]
Table 5-27 Server SSH command parameters
Parameter Description
ENABLE|DISABLE Enables or disables SSH session access to the SCS.
AUTH=<auth> SSH authentication methods. You must enter the entire value. Abbreviations are not permitted. Valid
values are:
PW Password authentication
KEY Key authentication
PW|KEY Password or key authentication
KEY|PW Key or password authentication
PW&KEY Password and key authentication
KEY&PW Key and password authentication
Default = PW
Show commands
The Show command has several forms, as listed in Table 5-28.
Table 5-28 Show command summary
Command Description
Show NFS Displays NFS mount status and configured values
Show NTP Displays configured NTP values
Show Port Displays port information
Show Port In/Out Displays how carriage returns and linefeeds are treated
Show Server Displays SCS configuration information and statistics
Show Server CLI Displays SCS CLI settings
Show Server PPP Displays SCS PPP settings
Show Server RADIUS Displays SCS RADIUS settings
Show Server Security Displays SCS authentication, connection, and security lock-out settings
Show Server SNMP Displays SNMP configuration information
Show User Displays user configuration and session information
Show NFS command
The Show NFS command displays NFS configuration information and the current mount status. If a mount error
occurred, the display also includes the error message returned by the NFS server.
If NFS has never been enabled on the SCS, the default values appear. If NFS was previously enabled, successfully
configured, then later disabled, the display will retain the configured address, mount point, and file type values.

HP 16-port SCS Specifications

General

Brand	HP
Model	16-port SCS
Category	Network Hardware
Language	English