SCS commands 74
User commands
The User command has several forms, as listed in Table 5-38.
Table 5-38 User command summary
Command Description
User Add Adds a new user to the user database
User Delete Deletes a user from the user database
User Logout Terminates an active session of a user
User Set Changes the configuration information of a user
User Unlock Unlocks a locked-out user
User Add command
The User Add command adds a new user to the SCS user database. The user database holds a maximum of 64
user definitions. See “Managing User Accounts” and “Access rights and levels.”
Access right: USER
Access level: ADMIN or APPLIANCEADMIN
Syntax:
user add <username> [password=<pwd>] [sshkey=<keyfile>] [ftpip=<ftpadd>]
[key=<sshkey>] [access=<access>] [group=<group1>[,<group2>...]]
Table 5-39 User Add command
Parameter Description
<username> 3 to 16 alphanumeric character user name. User names are case-sensitive.
PASSWORD=<pwd> 3 to 16 alphanumeric character password. Passwords are case-sensitive.
SSHKEY=<keyfile> Name of uuencoded public key file on an FTP server. The maximum file size that can be
received is 4 KB. If this parameter is specified, you must also specify the FTPIP parameter.
FTPIP=<ftpadd> FTP server IP address. If this parameter is specified, you must also specify the SSHKey
parameter.
KEY=<sshkey> Uuencoded SSH key.
ACCESS=<access> Command and port access rights or level. You may specify multiple access rights, separated by
commas, or a level. Valid values for access rights are:
P<n>—Access to the specified port number
P<x-y>—Access to the specified range of ports
PALL—Access to all ports
USER—User configuration access rights
PCON—Port configuration access rights
SCON—Configuration access rights
SMON—Monitor access rights
BREAK—Can issue Port Break command
Valid values for access levels are:
ADMIN—PALL, USER, SMON, PCON, and BREAK access rights
APPLIANCEADMIN—PALL, USER, SCON, SMON, PCON, and BREAK access rights
Default = PALL, SMON
GROUP=<group> Name of port group to which the user will be assigned. Up to 16 port groups, separated by
commas, can be defined for a user.
Examples
The following command adds the user name JohnDoe, with the password secretname, access to ports 2, 5, 6, and 7,
and user and monitor access rights.
> user add JohnDoe password=secretname access=P2,5-7,user,smon
The following command adds the user name JaneDoe, with access to all ports. The name of the SSH public user key
file is SCS_key2.pub. This file is located on the FTP server at IP address 10.0.0.3.
To Next Page
Loading...
Need help?
General
