SCS commands 69
Table 5-30 Show Port command display fields for TD=Console
Field Content
Power Signal Signal and state being monitored for device power status (from Port Set command). If monitoring
is disabled, this field indicates None.
Port name Port name assigned with the Port Set command or the default name (last three octets of MAC
address plus the port number).
Port NFS Enable indicates NFS is enabled, and Disabled indicates NFS is disabled (from Port NFS
command).
File NFS file name (from Port NFS command).
Size threshold NFS size threshold (from Port NFS command).
Time threshold NFS time threshold (from Port NFS command).
Port NFS Status Status of NFS history file operations.
Current file Current NFS file name.
User * User name (from User Add command).
Level * User’s access level (from User Add and User Set Access commands).
Access * User’s access rights (from User Add and User Set Access commands).
Groups Group names.
Port Access * Indicates if a user can connect to the port BY GROUP or BY PORT. If there is any group defined for
any ports (which can be determined with a show Port Groups command), each user can connect BY
GROUP, unless a user’s access rights include PALL, in which case, a user can connect BY PORT. If a
user is assigned an empty group (with no ports in it) or no groups at all, that user may lose access
to any port when there is a group defined for any port.
Locked Indicates if the port is LOCKED or UNLOCKED. If security lock-out is disabled, N/A displays. See
“Using security lock-out” for more information.
Duration * Duration of the session of the user.
* Displayed only when the command specifies a single port that has a current connection.
The Show Port Names command displays a list of port numbers and their names. If a port has not been assigned a
name with the Port Set command, the default name appears.
The Show Port Groups command displays a list of port numbers and group assignments.
The Show Port Alert command displays port alert strings.
To Next Page
Loading...
Need help?
General
