Technical specifications 84
Table 6-5 NFS error codes
Error code Description
27 From the remote procedure call: broadcasting is not supported.
28 From the remote procedure call: the name-to-address translation failed.
29 From the remote procedure call: an unspecified error occurred.
30 From the remote procedure call: an asynchronous error occurred.
31 From the remote procedure call: an asynchronous error occurred.
32 The operation was not permitted.
33 No such file or directory could be located.
34 An I/O error occurred.
35 No such device or address could be located.
36 A bad file number was encountered.
37 Out of memory.
38 Permission was denied.
39 The file already exists.
40 A cross-device link was encountered.
41 No such device could be located.
42 The specification is not a directory.
43 The specification is a directory.
44 An invalid argument was encountered.
45 The file was too large.
46 There is no space left on the device.
47 This is a read-only file system.
48 There were too many links.
49 The network is down.
50 The network is unreachable.
51 The network dropped the connection because of a reset.
52 The software caused a connection abort.
53 The connection was reset by a peer.
54 No buffer space is available.
55 The transport endpoint is already connected.
56 The transport endpoint is not connected.
57 Cannot send after a transport endpoint shutdown.
58 The connection timed-out.
59 The connection was refused.
60 The host is down.
61 There is no route to the host.
62 A stale NFS file handle was encountered.
63 The operation was not allowed because the caller is either not a privileged user (root) or not the owner of the
operation’s target.
64 The specified file or directory name does not exist.
65 A hard I/O error (such as a disk error) occurred while processing the requested operation.
66 The specified device or address does not exist.
To Next Page
Loading...
