HP 5334B - Page 17

4.
Set the HP 5334B as follows:
COM A
................................................................................................................... OFF
CHAN A and
B 500 ............................................................................................ OFF
Observe: The HP 5334B front panel displays 10.000 000 0 MHz + 0.2 Hz. Channel A trigger light flashing
and Channel
B light not flashing.
5.
Set the HP 5334B as follows:
CHAN A 50i2 ........................................................................................................ ON
Observe: The HP 5334B front panel displays all dashes and Channel A trigger light stops flashing.
6. Set:
........................................................................................................
CHAN A 50 R OFF
Observe: Condition prior to switching in 50R impedance.
7. Set:
CHAN A
XI0 A'ITN ........................................................................................... ON
Observe: The HP 5334B front panel displays all dashes and Channel A trigger light stops flashing.
8. Set:
........................................................................................... CHAN A XI0 ATTN OFF
Observe: Condition prior to switching in XI0 attenuator.
9. Set:
100 kHz FILTER A .............................................................................................. ON
Observe: The HP 5334B front panel displays all dashes and Channel A trigger light stops flashing.
10. Set:
.............................................................................................. 100 kHz FILTER A OFF
Observe: Condition prior to switching in 100 kHz Filter.
11. Set:
................................................................................................................... COM A ON
........................................................................................................... FUNCTION FREQ B
Connect the rear panel TIME BASE oscillator signal to the Channel B Input.
Observe: The HP 5334B front panel stops updating and the trigger lights stop flashing.
12. Set:
................................................................................................................... COM A OFF
Observe: The HP 5334B front panel displays 10.000 000 0 MHz 2 0.2 Hz. Channel B trigger light flashing
and Channel A trigger light not flashing.
13. Set:
CHAN B 50R ........................................................................................................ ON
HP 5334B - Service Manual
4-7