HP 5334B - Page 28

t
HP8660A/C/D
SIGNAL GENERATOR REF IN
5)
0
50n FEEDTHROUGH
J
I
TSM-L2 1
Figure 4-4. Channel A Frequency and Sensitivity Setup,
80 MHz - ZOO MHz
Equipment:
...................................................................................................
Signal Generator HP 8660AlC
Procedure:
1.
Set the signal generator as follows:
Frequency
............................................................................................................... 80 MHz
Amplitude
............................................................................................................. 35 mV rms
2.
Set the HP 5334B as follows:
Reinitialize the
5334B.
FUNCTION ........................................................................................................... FREQ A
....................................................................................................................... SENS ON
CHAN A TRIGISENS control ........................................................................... fully CW
3. Connect the signal generator to the HP 5334B Input A using a 500 feedthrough connector as shown in
Figure 4-4.
VERIFY: The Counter displays 80 MHz k 2 Hz.
4.
Record the measurement on the Performance Test Record Card, line 13.
5.
Set the signal generator as follows:
............................................................................................................... Frequency 100 MHz
.............................................................................................................. Amplitude 35 mV rms
VERIFY: The Counter displays 100 MHz + 2 Hz.
HP 5334B - Service Manual
4-18