HP 5334B - Page 46

9. Set the signal generator as follows:
Frequency
............................................................................................................... 1300 MHz
Amplitude .............................................................................................................. + 0.5 dBm
NOTE
This amplitude provides 75 mV rms to the Channel C Input when using the
10 dB attenuator.
VERIFY: The Counter displays 1300 MHz + 20 Hz.
10. Record the measurement on the Performance Test Record Card, line 56.
Failure: Perform Section V, Adjustments, paragraphs 5-21 and 5-22.
HP 5334B - Service Manual
4-36