Checking the HP Command View EVA version
NOTE:
If upgrading from HP Command View EVA version 6 to version 7 or later, licenses must be migrated.
See the HP Command View EVA installation guide for more information.
To check the HP Command View EVA version, perform the following steps:
1. Open HP Command View EVA on the management server.
The HSV Storage Network Properties window opens.
Figure 1 HSV Storage Network Properties window
.
2. Click Help in the Session pane.
The full version is displayed in the top right window bar. If the version listed is earlier than the
minimum supported version, it must be upgraded.
Figure 2 HP Command View EVA online help
.
TIP:
The version number is also shown at the bottom of the logon screen.
Checking the storage system hardware
Estimated time to complete: 15–20 minutes
HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array Updating Product Software Guide (XCS
6.220) 15
To Next Page
Loading...
Need help?
General