Figure 21 Code Load Disk Drives — Page 3 window
.
11. Click Finish.
Upgrading firmware on an individual disk
If it is necessary to upgrade the firmware on an individual disk, the firmware and installation instructions
can be downloaded from the following website:
http://www.hp.com/support/evadiskfirmware
IMPORTANT:
Upgrading disk drive firmware on an individual disk can be performed online or offline, unless the
disk is a member of a disk group that contains Vraid0 virtual disks. If so, the disk must be ungrouped
before the disk drive firmware can be upgraded.
Step 7. Entering storage system passwords
Estimated time to complete: 10–15 minutes
NOTE:
• This step is only required if you use password protection on the storage system.
• When you add a system password to the controller, you must also enable password access in HP
Command View EVA. The two work in conjunction with one another.
Long passwords (up to 16 characters) are supported. The password must meet the following
requirements:
HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array Updating Product Software Guide (XCS
6.220) 59
To Next Page
Loading...
Need help?
General