5. Select Customer Details and enter the following information:
a. Enter your name in Name. This information is required.
b. Enter your e-mail address in E-Mail to receive the completed report. This information is
required. It is not necessary to have an e-mail address connected to the EVA controller. You
should enter the e-mail address where you typically receive e-mail. You can enter multiple
email addresses in E-Mail by separating entries with a semicolon (;).
c. Enter data in the remaining boxes as appropriate. This information is included in the reports,
but is not required.
d. To send your raw data to HP automatically when creating a report, select Automatically
e-mail the collected raw data on completion.
e. Click Next to save and proceed.
NOTE:
For information on using Advanced Settings, see the SAN Visibility user guide.
Creating a report
Once you have configured SAN Visibility for data collection, you can create a report. There are two
methods for creating a report:
• Automatically—Automatically e-mails the data to HP when collection is complete. This requires
you to know the SMTP address of your mail server. If you have external e-mail access from your
environment, this is the preferred method.
• Manually—Requires you to manually send the data to HP. If you do not have external e-mail access,
use this method.
HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array Updating Product Software Guide (XCS
6.220) 21
To Next Page
Loading...
Need help?
General