*RST
Reset command.
Syntax
*RST
Caution
I(U
The
*RST
command will overwrite all instrument set-ups stored in
the instrument memories.
Definition
The reset setting (standard setting) stored in ROM is made the
current instrument setting, and is also stored in all the instrument's
memories.
Pending
*OPC/*OPC?
actions are cancelled.
Instrument state: the instrument is placed in the idle state awaiting
a command.
The following are not changed:
VXIbus (interface) state
Instrument interface address
Output queue
Service request enable register (SRE)
Standard event status enable register (ESE)
Lists
The commands and parameters of the reset state are listed in the
following table.
5-40
Command
Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
