-
INlTiate
Subsystem Syntax
:CONTinuous
Parameters
Comments
The :INITiate command subsystem controls
the
initiation of the
sweep generator for one cycle. INITiate enables the module whilst
ABORt disables it.
:INITiate:CONTinuous ONJOff1110 enables or disables continuous
sweep or waveform output from the
HP
E1440A
.
Parameter
Name
ONIOFF(110
Parameter
I
Range
of
w
Continuous Sweep Operation:
Continuous sweep is enabled with
the :INIT:CONT ON or :INIT:CONT
1
command.
w
Non Continuous Operation:
Non Continuous operation of
the
HP
E1440A is enabled with the :INIT:CONT OFF or
:INIT:CONT
0
command.
rn
Stopping Continuous Sweep:
Send the
":INIT:CONT 0FF;:ABORt
"
command.
Related Commands:
[:IMMediate]
The :INITiate:IMMediate command causes the module to start
a
sweep immediately.
Comments
r
If the instrument is not in an idle state, then this command has no
effect and an error code is generated
:INIT[:IMM] is an event and therefore has no *RST state. A *RST
command will however set the instrument to idle.
w
If :INIT:CONT OFF is selected, when :INIT[:IMM] is commanded,
the system is enabled for one cycle only. The instrument then
reverts to idle awaiting another :INIT[:IMM] command.
w
If
:INIT:CONT ON is selected, the instrument starts sweeping as
soon as it enters :FREQ:MODE, SWEep or LIST
Command Reference
5-
11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
