ABORt
ABORt
SCPl
Command
This section describes the Standard Commands for Programmable
Reference
Instruments (SCPI commands) that may be used for the
HP
E1440A.
Commands are listed alphabetically by subsystem and also within
each subsystem.
ABORt
The ABORt command subsystem removes the synthesizer from the
INITiate state and places it in an idle state.
Subsystem Syntax
:ABORt <event>
Comments
Related commands:
:INITiate:CONTinuous, :INITiate[:IMMediate]
rn
*RST Condition:
After a reset, the synthesizer acts as though an
:ABORt has occurred
:ABORt cancels any impending commands
Example
Stopping a Sweep with :ABORt
Program
10 OUTPUT 70911;
" :
INIT: CONT ON"
20 OUTPUT 70911; ":FREq:MODE
SWE"
30 OUTPUT 70911; ":ABORV
or:
10
OUTPUT 70911; ":INIT:CONT OFF"
20
OUTPUT 70911; ":FREq:MODE SWE"
30 OUTPUT 70911; ":INIT"
40 OUTPUT 70911; ":ABORU
Result
Select continuous sweep and
initialize
Sets in sweep made and
starts immediately
Sweep stops and resets, then
restarts immediately
Select single sweep
Sets to sweep mode (sweep is
in reset state)
Sweep starts
Sweep stops and is set
to
reset state, (asynchronous)
5-8
Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
