Modulation Frequency Range
DC
-
5
kHz
Frequency
Sweep
Sweep Sequence Modes:
Single, continuous.
Sweep Function Modes:
Multi
-
Interval:
Upto
50
different
intervals can be sequenced and repeated in any
order in a sequence which can contain upto
100
intervals.
Frequency-swit ching-time between intervals (typical)
:
52
ms for a
100
kHz
step.
53
ms for a
1
MHz
step.
520
ms for a
20
MHz
step.
Linear Sweep
(settable for each interval)
Sweep time 0.01
to
lo5
Maximum sweep width
full frequency range of the main signal
output for the waveform in use.
Minimum sweep width
0 Hz
Minimum sweep rate 0.2 Hz/s
One marker frequency can be set in each interval.
Logarithmic Sweep (settable for each interval):
(sweep
up
only)
Sweep time 0.1 to
lo5
Maximum sweep width
full frequency range of the main signal
output for the waveform in use.
Minimum start frequency
1
Hz
Minimum sweep width
1
decade
Multi Marker:
Linear sweep (only)
Sweep time 0.01 to
lo5
Maximum sweep width
full frequency range of the main signal
output for the waveform in use.
Minimum sweep width 0
Hz
Upto
9
markers can be set in this one, dedicated, interval.
Phase Continuity:
Sweep
is
phase continuous over the full frequency range of the main
output for
all
sweep modes.
A-6
Specifications
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
