SCPl
Command Quick Reference (continued)
Sub-command
&
Parameter
Description
JST
Output signal sweeps to a set of accompanying lists
FREQUENCY
Specifies frequency points for list
:STARt <num>[,<num]..
List of sweep start frequencies
:POINts?
Returns no. of entries in start list
:STOP
List of sweep stop frequencies
:POINts?
1
Returns no. of entries in stop list
:MARKer
List of sweep markers
:POINts?
Returns no. of markers in list
:
STATe Sets markers onloff
:POINts?
Returns no. of entries in state list
:SPACing
List of sweep type, linear or logarithmic
:POINts?
Returns no. of entries in spacing list
:DWELl
Specifies dwell time occurances for lists
:POINts?
Returns no. of entries in dwell list
:SEQuence
Defines a sequence for stepping through a list
:POINts?
Returns no. of entries in sequence list
Sets marker on or off
[:ADJust]
Controls phase offset value relative to reference
:STEP
Controls step size in radians (can specify DEG or RAD)
:REFerence
:TIME Sets duration of sweep
:RETRace
Sets duration of sweep retrace time
:AUTO ONlOFFlONCE
Couples or isolates RETRace time tolfrom TIME
:CONDition?
Returns content of associated condition register
:ENABle <integer no.> Allows event register to be pre-loaded
:ENABlc? Read event register
:PTRansition <integer no.>
Loads a positive transition filter
:PTRansition?
Reads the positive transition filter
D-2
Command
Quick
Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
